Pecha Kucha on 3D Printing
Check out this 6-minute overview of 3D printing on Pecha Kucha
How to Fold Part 4
Folding a point to an edge
Bring the corner point down to meet the 90-degree (right angle) corner. On the side that has straight edges, make sure the edges line up. Then crease the fold.
Fold on the table, not in the air.
How to Fold Part 3
Folding adjacent edges of different lengths
Bring the edges of the angle together and line them up. To crease the fold, start from the pointy end.
Fold on the table, not in the air.
How to Fold Part 2
Folding adjacent edges
Bring the opposite corners of the paper together and line them up. Make sure the edges also line up, all the way to the point of the angle. Then crease the fold.
Fold on the table, not in the air.
How to Fold Part 1
Folding opposite edges
Bring the opposite edges of the paper together and line them up from corner to corner. Then crease the fold.
Fold on the table, not in the air.
Soma Cube Nets
Are your soma cubes taking too long to print in the 3D printer?
Try making them with these nets. Print them out, cut on the solid lines, and fold on the dotted lines. Use glue on the glue tabs to close the shape.
These may be a bit challenging.